Versions Compared
compared with
Key
- This line was added.
- This line was removed.
- Formatting was changed.
Comment:
changelog 0.5.0
Firmware
Downloads:
| Tip | ||
|---|---|---|
| ||
We normally send e-mail notifications upon release of new firmware versions. To receive this mails you can sign up to the Lobaro newsletter here. Subscribe to our email newsletter here Make sure to select the "Firmware Updates" checkbox! |
Changelog
0.5.0 - 2020-08-12
Added
- Power-On Selftest
Changed
- BREAKING CHANGE: Default values for
JoinEUI,AppKey,NwkKeychanged! - Uses LoRaWAN-Stack that was certified for wMBus-Bridge
- Implement changes in LoRaWAN-Stack that happend during certification. Implements some edge-case.
- Make remote config feature robuster, e.g. when sending downlinks with ACK request.
Fixed
- Fixed Mixup of Sensors that could trigger endless loop
0.4.1 - 2020-07-21
Fixed
- Fix payload of sensor data
0.4.0 - 2020-06-30
Changed
- Use lobawan stack v1.2.2
- Sensors from
SensorIdOrderthat are missing will still be uploaded (with -0x8000 value) - When
SendSensorId==falseuploads are done on port 3 (was port 2), - Enable 3.3V step-up only if voltage is below 3.1V (was: if below 3.3V).
- Support up to 32 sensors (only 25 supported in
SensorIdOrder).
0.3.3 - 2019-08-01
- Added ADR config parameter
0.3.2 - 2019-08-01
- Fixed Onewire init after DeepSleep
0.3.1 - 2019-07-29
- Temp sensors will be printed and sent sorted by parameter "SensorIdOrder" and by ID or just by ID if parameter "SensorIdOrder" is empty
0.2.0 - 2019-02-15
- Add parameter "SendSensorId" to allow skipping sensor IDs in payload
0.0.3
- Bugfixes in LoraWAN stack
- LoRaWAN Support for RX1 DataRate Offset
0.0.2
- Don't send sensor type with ID (support 6 sensors in 50 bytes)
- Add TestMode config value
- Add SendInternalTemp config value
- Internal sensor is send first if SendInternalTemp = true
| Table of Contents |
|---|